Published at Saturday, December 30th 2017. by Alexandra Christian in Home Design.
For those who plan on living in their homes until they die, this type of house design is excellent because it will accommodate occupants in any change of life. If an occupant becomes suddenly disabled or eventually must have certain handicap amenities in areas like the bathroom due to aging issues, this design allows for changes in life that are bound to occur.
The area that received the most attention was the kitchen. 22 percent of respondents in the A.I.A report said the size of the kitchen is increasing in new home design and construction. The rediscovered focus on size opens up the possibility of remodeling and addition work that can be done in this popular and lucrative sector. The dominant feature requested for new kitchens are renewable materials. Almost half of the surveyed architects said that materials such as bamboo, cork and concrete are becoming increasingly popular.
The structure over the hangar door is an important consideration. Hangar doors are usually quite wide varying from a minimum of 40 feet on up to greater than 55 feet wide. The header or beam spanning across the top of the door needs to be considered structurally. One way to handle this is by placing a steel I-beam across the door which will hold the weight of the roof. There are several disadvantages to this including higher construction costs due to the steel fabrication issues. Another disadvantage is that the beam bottom will usually fall well below the ceiling of the hangar causing the hangar door to be shorter than the ceiling height. Another, perhaps better, way to handle this is to use some sort of a gable roof or a modified gable roof over the hangar door. This allows the truss system of the roof to act as its own beam. Often the truss that spans over the door is a multi-ply truss and its bottom can be even with the ceiling height of the hangar. This allows the door to be higher and nearly the same height as the ceiling of the hangar. When designing the hangar discuss this aspect with the designer engineer who will work with you to determine the best solution.
Because lot sizes vary from large to small, setbacks may be an issue. Another factor is whether or not the site is level or has a slope. Sloped sites are quite workable but present unique challenges that must be considered. Generally on sloped lots the hangars are placed on the lower section and the home on the higher section which allows the home and hangar to blend with one another nicely.
Here are some of the best benefits of a universal home design:
Important design elements